Hi everyone! My name is Kristi, I am a stay-at-home mom of two beautiful kids. We live in Rochester, MN where my husband is completing a medical residency.
We bought our first home in June 2011, and we had lots on our to-do list. Since my husband is typically very busy with work, most of the Honey-do list has been left to me.
In order to document the changes we've made to our home, I created my blog KrisKraft.
A few years ago I bought a large mirror that was a great price, but unfortunately pretty average in the looks department. I used it in our old apartment; however, after we moved, I decided the mirror needed a makeover before I could get excited about displaying it again. Using Restoration Hardware's salvaged boat mirror as my inspiration, I was able to replace a so-so mirror with something that I love.
press board cut a few inches larger than your mirror on all sides
1" x 6" boards (I used maple wood because I knew it would take stain better than pine or poplar and I like the grain better than oak)
1" x 2" boards (again maple)
finishing supplies (stain, wax)
1) Place Liquid Nails on the back of the mirror. Center and attach the mirror to the press board and let it set for the recommended amount of time.
3) Cut the 1" x 2" boards to size. As shown below, you'll need to cut each end at a 45-degree angle in order to frame the 1" x 6" boards.
4) Once the boards are cut, it's time to distress. My husband and I used a few different techniques including dragging the boards across our driveway and using a chisel to gouge and scrape the wood.
6) Once distressed, you can of course finish the wood with any stain or paint you like. As I mentioned earlier, I was trying to achieve a weathered look similar to Restoration Hardware's mirror, which required some experimentation. In the end, I used two coats of Minwax Jacobean stain and two coats of Minwax Classic Grey stain. After staining, I also applied one coat of Fiddes & Sons' wax.
8) Once the 1" x 6" boards are set, you can then attach the 1" x 2" trim pieces with glue and nails. I again used my 18-gauge finish nailer and you can hardly notice the nail holes, particularly with all the other holes and gouges we intentionally made.
Here is the mirror all finished.
Thank you Kari for having me as a creative guest! I feel so lucky to be featured here at Ucreate.
I hope you all will stop by, say hello and check out my other projects at KrisKraft.
How amazing is Kristi?? I always wondered how you can get that deep distressed look and she makes it looks so easy! You will not want to miss her blog so hop on over there right now and check out her many other GORGEOUS projects like these…